Connecting Input Source Signals; Connecting The Wired Osd Controller - AG Neovo TX-1502 User Manual

MAKING CONNECTIONS

2.2 Connecting Input Source Signals

Input source signals can be connected with either of the following cables:
DisplayPort HDMI VGA
DisplayPort HDMI VGA

2.3 Connecting the Wired OSD Controller

Connect the wired OSD controller (optional, not supplied) to the RJ11 connector of the LCD monitor.
MENU
SELECT
• DisplayPort
Connect one end of a DP cable to the DisplayPort
connector of the LCD monitor and the other end to the
DisplayPort connector of the computer.
• HDMI
Connect one end of an HDMI cable to the HDMI connector
of the LCD monitor and the other end to the HDMI
connector of the computer.
• VGA
Connect one end of a D-Sub (VGA) cable to the D-Sub
(VGA) connector of the LCD monitor and the other end to
the D-Sub (VGA) connector of the computer.
Note: To ensure the LCD monitor works well with your
computer, please configure the display mode of
your graphics card to make it less than or equal to
1024 x 768 (for TX-1502), 1280 x 1024 (for TX-
1702 & TX-1902), or 1920 x 1080 (for TX-2202)
resolution and make sure the timing of the display
mode is compatible with the LCD monitor. For
compatible Video Modes of your LCD monitor,
please refer to "6.2 Timing" on page 33.
RJ11
17
MENU
SELECT