Table of Contents
Advertisement
After the sensor has been set up, this
screen will appear when you connect
to the sensor.
Choosing SET COUNTING AREA
will guide you through the laser
field setup. See page 12 for full
run-through of screens.
©BEA
| Original Instructions
75.5929.01 LZR-SIGMA 20210630
ADDITIONAL FEATURES
Choosing SET DEVICE INFORMATION
will guide you through the sensor
information setup. See page 11 for
full run-through of screens.
Choosing COUNTING PROOF will allow
you to perform a manual check to verify
that the device is counting properly and
that setup was successful.
Choosing SET DEVICE NETWORK will
display the information regarding the
network that the sensor is connected to.
CAUTION: These settings should
only be modified by the site network
administrator.
Choosing RESET DEVICE will give
options for performing a full reset or
partial reset.
Partial = clears only field limits
Full = clears all, including sensor
information
Page 14 of 17
Advertisement
Table of Contents
