BEA LZR SIGMA Original Instructions Manual page 12

Hide thumbs Also See for LZR SIGMA:

Table of Contents

Now that all of the applicable sensor information has been entered, continue to follow the prompts in the app to guide

you through the sensor setup.

One sensor = NO

Multiple sensors = YES, see Application

Note 78.6034 for more information

©BEA

| Original Instructions

75.5929.01 LZR-SIGMA 20210630

Allow the sensor to learn the field.

At this step, the sensor is learning the

height and will set left and right limits

according to the maximum allowed

width based on mounting height.

MANUAL ADJUSTMENT (preferred): Measure the width of the entryway and increase or decrease

limit accordingly using the + and - buttons. BEA recommends adding 6" to your dimensions to ensure

your area is fully covered.

AUTOMATIC ADJUSTMENT: Follow prompts.

SETUP

You may manually adjust left and

right limits by simply clicking the edit

button beside the given dimension.

Verify that the learned height is

accurate. If not, see Troubleshooting.

Be sure to press CONFIRM

when finished.

Page 12 of 17

Table of Contents