Harman Stove Company DVC500-C Manual page 18

This setting will produce medium heat with the
Distribution Blower on "low".
This setting will produce a room temperature of 70
degrees with the Distribution Blower at "medium" speed.
This setting will produce continuous maximum heat output
with the Distribution Blower at full speed.
Operation:
Fig. 16
Keep coal off
ledges
When to use "Stove Temp Mode"
In "Stove Temp Mode" the Stove Temp Dial
determines the temperature of the stove. Heat
output and fuel consumption will remain constant.
This makes it possible to tell how long a hopper
full of coal will last. The distribution blower speed
will vary according to the position of the mode
selector, between "low" and "high", fig. 16.
When to use "Room Temp Mode"
In "Room Temp Mode" heat output is con-
trolled automatically by the Room Sensing Probe.
When the Room Sensing Probe calls for heat, the
stove will increase output. When the Room Sens-
ing Probe is getting close to the set temperature,
the stove will begin to level off output and keep
the fire burning at just the right temperature to
maintain that setting.
High output is determined by the Feed Rate.
The maximum Feed Rate should be set for 1
2" of ash in front of fire.
In "Room Temp Mode" fuel consumption is
sacrificed for exact room temperature. Therefore,
as it gets colder, more coal will be burned auto-
matically.
The distribution blower speed will vary
according to the position of the mode selector.
Fig 17
1
/
18
" to
2