Harman Stove Company DVC500-C Manual page 7

Door Assembly/Installation Tips
Door Glass
* Rope the glass carefully to insure proper
sealing.
* Apply the rope exactly along the edge of the
external face of the glass, not overhanging or
pressed too far in from the edge.
o
* Make sharp 90
* Overlap the ends of the rope at the upper left
or right corners.
Glass Retainer Clips
* Use the glass retainer clips and screws
supplied in the door kit.
* Use a 1/8" Allen wrench to tighten the glass
clips to cast door with 10-24 x 3/8" screws
supplied.
BRASS HANDLE
HANDLE
BOLT
SET SCREW
WOOD HANDLE
turns at the corners.
HINGE PINS
4 GLASS
RETAINER
CLIPS
Paw Bolt
* The paw bolt should be turned into the door
from the inside approximately 14 turns.
* With the set screw removed, turn the brass
elbow onto the paw bolt approximately 5
turns, or until a 1/16" clearance is achieved
between the elbow and the door face (make
sure to stop on the flat spot of the paw bolt).
* The set screw on the brass elbow must be
aligned to contact the flat spot on the paw bolt,
then tighten using a 5/32" Allen wrench.
* After attaching the door handle, close and
latch the door by turning the handle to the six
o'clock position. During this process observe
to see that the door rope is being compressed
properly.
* If it does not compress, loosen the set screw
and turn the paw bolt one additional turn into
the door. Repeat as required to insure a tight
seal.
DOOR
GLASS
4 GLASS
RETAINER
BOLTS
PAW BOLT
GLASS GASKET
7