Advertisement

SC50VT
AIR COMPRESSOR
OWNER'S MANUAL
FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SC50VT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SGS SC50VT

  • Page 1 SC50VT AIR COMPRESSOR OWNER’S MANUAL FOR YOUR SAFETY PLEASE READ THESE INSTRUCTIONS CAREFULLY AND RETAIN THEM FOR FUTURE USE.
  • Page 2: Main Components

    This compressor contains surfaces which may reach a high temperature during operation. Never operate with the motor housing removed. Air and condensation water can burst from the SC50VT Model compressor when the drain plug is removed. 1.5 kW / 2 HP...
  • Page 3: Safety Precautions

    KEEP THE WORK AREA CLEAN: Cluttered areas mean accidents, so alcohol, drugs or any medication that makes you drowsy. clear the work area of all unnecessary tools, debris and furniture. WWW.SGS-ENGINEERING.COM PAGE 4 PAGE 5...
  • Page 4 • The compressor is designed to be used in dry rooms. It is prohib- ited to use the compressor in areas where work is conducted with DO NOT USE EXTENSION LEADS: Using extension leads can cause sprayed water. your compressor motor to burn out. Only use extension hoses. WWW.SGS-ENGINEERING.COM PAGE 6 PAGE 7...
  • Page 5: General Maintenance

    The safety valve has been set for the highest permitted pressure of the air tank. It is prohibited to adjust the safety valve or remove its seal. Actuate the safety valve from time to time to ensure that it works when required. WWW.SGS-ENGINEERING.COM WWW.SGS-ENGINEERING.COM PAGE 8...
  • Page 6: Operation And Adjustment

    6. Release the excess pressure by switching off the compressor and using the compressed air which is still left in the air tank, e.g. with a compressed air tool running in idle mode or with a blow gun. WWW.SGS-ENGINEERING.COM PAGE 10 PAGE 11...
  • Page 7: Maintenance

    9. Before restarting the motor by pushing the reset button, check the air compressor carefully, find the causes of the trouble and solve them, check the pressure in the air tank and make sure it is under 0.8Mpa. WWW.SGS-ENGINEERING.COM PAGE 12 PAGE 13...
  • Page 8: Replacement Parts Diagram

    Leave this compressor for a good while until you reset it. If the compressor turns off again on reset you should not keep running it as it may be damaged and the system may be unsafe. WWW.SGS-ENGINEERING.COM PAGE 14 PAGE 15...
  • Page 9 SGS Engineering (UK) Ltd Part Qty Part No No Part Qty Part No West Side Park Plastic housing 907106 45 Plastic housing 907127 Raynesway Power switch 905063 46 Pipe 905102 Elbow connector 905064 47 Safety valve 905103 Derby, DE21 7AZ...

Table of Contents

Save PDF