Advertisement
Table of Contents
PUMP-FORM-138 Ver:1 Appr/Eff Date:01/15/2021 - 01/15/2021 Approved By: CPIERCE
1) Remove PPI from heat sealed bag when ready to sample. Save the bag for later use with
same sampler.
2) Remove the black cap. Connect PPI to pump tubing after allowing the pump to warm up for
1.5 minutes. You are now sampling.
PPI Sampling Quick Start Guide
Color will vary depending on model.
BEFORE SAMPLING
Page 1 of 3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SGS GALSON
Summary of Contents for SGS GALSON
- Page 1 PUMP-FORM-138 Ver:1 Appr/Eff Date:01/15/2021 - 01/15/2021 Approved By: CPIERCE PPI Sampling Quick Start Guide Color will vary depending on model. BEFORE SAMPLING 1) Remove PPI from heat sealed bag when ready to sample. Save the bag for later use with same sampler.
- Page 2 1) Disconnect the sampler from pump tubing and replace the black cap back on the outlet of the PPI. Place the provided sticker over the inlet of the PPI to seal the sample. 2) Place back in original sample bag and ship back to SGS Galson. Questions? Contact SGS Galson 247/365 at 1-888-432-5227 Page 2 of 3...
- Page 3 3) When calibration is complete, place the calibration adapter back in its bag and ship back to SGS Galson. CALIBRATION CHAMBERS ARE NOT DISPOSABLE AND MUST BE RETURNED TO SGS GALSON. FAILURE TO DO SO WILL RESULT IN REPLACEMENT FEES. Questions? Contact SGS Galson 247/365 at 1-888-432-5227...
Need help?
Do you have a question about the GALSON and is the answer not in the manual?
Questions and answers