Barco F70 Series User Manual page 14

3. Projector 3D setup
Image 3-2
2. Enter the menu Home/Installation/Display Setup, and select AutoStereo in the drop down menu.
(The other choices in the drop down menu is not applicable).
Image 3-4
3. Enter the menu Home/Installation/3D Setup, and set the dark time to 1600us or 1850us depending on which colorwheel in-
stalled.(The projector detect the color wheel, and only one option is available, depending on the color wheel).
Image 3-5
4. Run a 3D image or movie from the source.
Put on the 3D goggles, and verify by looking through the goggles with one eye at the time that only one image is visible in each
eye. A double picture or a shade of the picture from the other side shall not be observed. Repeat for both sides, and adjust the
Sync Delay slider until a "clean" picture is visible in each eye.
If the 3D picture looks a bit "strange" through the 3D goggles, the solution is to swap eyes by enabling the Swap eyes button in
the menu.
12
Image 3-3
601–0469 3D FUNCTIONALITY PULSE PLATFORM 27/02/2018