Summary Table For Maintenance Work - MIMAKI ML Tiger-1800B MK II Operation Manual

For internal safety features and under more protected conditions, a less frequent control is sufficient; It can be done during
the ordinary maintenance operations which require the opening of the protective guard.
The position of all safety electrical devices is shown on the electric circuit diagram.
Pneumatic system
Every 50 hours, check the proper operation of the pneumatic cylinder and all pneumatic devices on the machine.
Checking ink discharge
Regularly check whether ink is discharged correctly. Since the ink contains no toxic or harmful ones, it is discharged in
clean water in the tank.
Reapplying the main belt adhesive
At the end of each shift, verify the layer of permanent adhesive on the belt and reapply it if necessary by following the
procedures described in this manual (Procedure 7.14.2).
Checking ink level
Periodically check the ink levels in the tanks and if the level in a tank has reached the minimum level, replenish the tank
with the ink.
Confirming the belt cleaning unit
To inspect and clean the belt cleaning unit, you need to proceed as follows.
Procedure
S Mode Key
1
2 Main switch
3
4
5
Cleaning the station
Clean the print head washing station once a week, and eliminate ink residues (Section 7.16).
Maintenance around the print head
Clean around the print head once a week using a dedicated cloth. During this operation, move the carriage to the left side
of the machine.
For more information on maintaining the print head, see the dedicated manual.
• Mimaki assumes no responsibility for any injury or property damage caused by negligence in carrying out
the scheduled maintenance operations of the print head.
For the maintenance of the print head, see the manual provided by the manufacturer.

Summary Table for Maintenance Work

The table below shows maintenance work and the relative frequency (expressed in working hours).
Table
►
►
Checking brush washing tank
Indication
Verify that the drain is properly connected with the
main drain system.
After stopping the machine, turn the main switch to
0 - 1
"0".
Disconnect the tank from the electric, pneumatic
and hydraulic connections.
Completely empty the washing tank by turning the
valve.
Press on the locking system of the tank, manually
remove it and perform necessary maintenance.
End of procedure
Hour
8 Checking safety device
8 General cleaning of the machine
Chapter 9 MAINTENANCE
Feature
Operation
1
2
Reference
5-4
9
4
5
6
9-3