Disassembly And Repair - formlabs Form Cure Manual

error
Parts are
undercured or do
not have desired
mechanical
properties.
Post-cured parts
have tacky or
sticky surfaces.
7.3

Disassembly and Repair

All steps that involve opening the Form Cure and/or investigating internal
components should be done by skilled persons under the guidance of Formlabs or a
NOTICE
certified service provider.
Contact Formlabs or a certified service provider to receive repair instructions and authorization.
The following tools, equipment, and materials are needed for reparation tasks:
task
Replacing the
display assembly
Replacing the motor
assembly
Reseating the
ribbon cable
cause
Expired resin
Part was washed but not
fully dried before post-
curing
Part was not washed
before post-curing
Part was washed but not
fully dried before post-curing
required supplies
2.5 mm hex wrench,
replacement part(s)
2.0 mm hex wrench,
2.5 mm hex wrench,
replacement part(s)
2.5 mm hex wrench
solution
Check the expected lifetime of the resin used for
the print.
Fully dry all solvent off of parts before post-curing.
Wash liquid resin off of printed parts before post-
curing.
Fully dry all solvent off of parts before post-curing.
cause
The Form Cure display or knob has
stopped functioning.
The turntable has stopped functioning or
behaves erratically.
The Form Cure display or knob has
stopped functioning.
Troubleshooting and Repair | 27