Advertisement
Introduction
EXPLOSION HAZARD – CUTTING WITH FLAMMABLE OR OXIDIZING GASES
Do not use flammable or oxidizing gases with Powermax systems. These gases can cause
explosive conditions during plasma cutting operations.
An example of an oxidizing gas is oxygen. Examples of flammable gases are acetylene,
propylene, methane, and pure hydrogen. Refer to the Safety and Compliance Manual
(80669C) for more information.
Purpose
This Field Service Bulletin shows how to use the Hypertherm torch alignment guide accessory to do
bevel cutting on a track burner with a Powermax125 or a MAXPRO200.
Tools and materials needed
3/16 inch hexagonal key wrench
Digital level, or digital level application on a smartphone
Remote start pendant for the plasma cutting system if the track burner cannot start and stop
the plasma torch
Kit 528077 contents
Kit 528077 contains only the torch alignment guide and this Field Service Bulletin. Refer to
Figure
1.
Powermax125 / MAXPRO200
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before doing installation or maintenance.
The line-disconnect switch must REMAIN in the OFF position until all
installation or maintenance steps are complete.
See the Safety and Compliance Manual (80669C) for more safety
information.
WARNING
Field Service Bulletin
811280
Torch Alignment Guide for Bevel Cutting
3
Advertisement
