Receive Frames - ADF Web IO-Link / CAN User Manual

Industrial Electronic Devices

RECEIVE FRAMES:

By pressing the "Receive Frames" button from the main window for SW67866 (Fig. 2) the "Receive CAN Frames" window appears (Fig. 13).
The COB inserted in this table contains the Output data of IO-Link side. These frames are accepted by the converter.
Figure 13: "Receive CAN Frames Set Access" window
The data of the columns have the following meanings:
If the field "Enable" is checked, the CAN frame is enabled;
In the field "Cob-ID" the COB of the CAN frame is defined;
In the field "Type" the type of CAN packet use for the Cob-ID is defined (2.0A (11 bits) or 2.0B (29 bits));
In the field "Dimension" the number of byte of the COB (from 1 to 8) is defined;
The field "TimeOut" is used for put at zero the data on IO-Link side if the CAN frame doesn't arrive with a frequency less than the
time expressed in the field. If the value in the field is '0', it means that you don't want to use this;
In the field "Byte1" insert the address of the internal array where saving 1st byte of the CAN message;
In the field "Byte2" insert the address of the internal array where saving 2nd byte of the CAN message;
In the field "Byte3" insert the address of the internal array where saving 3rd byte of the CAN message;
In the field "Byte4" insert the address of the internal array where saving 4th byte of the CAN message;
In the field "Byte5" insert the address of the internal array where saving 5th byte of the CAN message;
In the field "Byte6" insert the address of the internal array where saving 6th byte of the CAN message;
ADFweb.com Srl – IT31010 – Mareno – Treviso
User Manual IO-Link / CAN
Document code: MN67866_ENG Revision 1.000
INFO: www.adfweb.com
Page 31 of 40
Phone +39.0438.30.91.31