EdilKamin Italiana Camini IDROPOINT Installation, Use And Maintenance Manual page 219

ADVICE IN CASE OF PROBLEMS
AL7 thermal safety (when the safety thermostat, situated in contact with the hopper, is triggered by the overheating of the pellet
hopper)
• Pellet overloading
AL8 no depression (when there is insufficient draught in the cold air aspiration pipe)
• Blocked cold air pipe
• Pressure switch failure
• Blocked silicon pipe
AL9 water temp. probe (when the stove no longer reads the probe)
• Broken water temp. probe
• Disconnected water temp probe
ALA hot water (when the temperature of the water in the boiler is higher than 90°)
• Check the water system
• Check the presence of air in the circuit
• Check the valves/taps of the circuit
• Check the cleaning of the stove
• Check the flue/chimney
• Contact the TAC
- 219
-