EdilKamin Italiana Camini IDROPOINT Installation, Use And Maintenance Manual page 218

ADVICE IN CASE OF PROBLEMS
In the case of problems, the stove will switch off automatically, and an indication of the cause will appear on the display
(see the various messages below).
Never pull out the plug when the stove is switching off automatically because of a failure.
In the case of automatic switch-off, the stove must be allowed to complete the entire procedure (15 minutes with an
acoustic signal), after which it can be restarted by pressing the key
However, do not restart the stove until you have found out the cause of the error and until you have CLEANED/EMP-
TIED the crucible.
SIGNALS OF POSSIBLE CAUSES OF AN ERROR, TIPS AND SOLUTIONS:
AL1 black out (this is not a stove error) (this takes place if there is no electricity for more than 5 seconds)
The stove has a 'black out' function. It the electricity supply is off for less than 5 seconds, the stove will switch on again, return-
ing to the function in progress before it switched off.
If the electricity supply is off for more than 5 seconds, the stove will go into 'black out' alarm, with consequent cooling phase.
The possible causes are listed below:
Stove status before black-out
OFF
PRE-LOAD
IGNITION
START-UP
OPERATING
FINAL CLEANING
STAND-BY
ALARM
ALARM RECORD
AL2 broken smoke temp. probe (when the stove can no longer read the smoke temperature)
• Broken thermocouple
• Detached thermocouple
• Smoke temperature out of range
AL3 hot smoke (when the temperature of the smoke exceeds the safety threshold)
• Blocked chimney
• Incorrect installation
• Stove clogged
• Too many pellets loaded, check pellet feed regulation (TAC)
NOTE: the "hot smoke" message appears when the first alarm threshold of 250° is exceeded, triggering automatic stove regu-
lation; only when the temperature of 270° is reached does the stove go into alarm mode and switches itself off.
AL4 fan fault (when the motor of the smoke extractor fan breaks down)
• Smoke extraction motor blocked
• Revolution counter breakdown
• Smoke motor breakdown
• Smoke motor thermostat triggered
AL5 ignition failure (when the smoke temperature does not reach the minimum threshold during the ignition phase)
• Probable spark plug failure
• Dirty crucible or too many pellets
• The pellets are finished
• Check the pellet safety thermostat (automatic reset)
• Blocked chimney
AL6 no pellets (when the pellets are finished)
• There are no more pellets in the hopper
• A gear motor failure
• The screw/pellet duct is blocked
• Too few pellets loaded, check pellet feed regulation
Interruption of less than 10 seconds
OFF
BLACK OUT
BLACK OUT
START-UP
OPERATING
FINAL CLEANING
STAND-BY
ALARM
ALARM RECORD
- 218
-
.
Interruption of more than 10 seconds
OFF
BLACK OUT
BLACK OUT
STAND-BY THEN RE-IGNITION
STAND-BY THEN RE-IGNITION
FINAL CLEANING
STAND-BY
ALARM
ALARM RECORD