Drain Pan (Optional); X-Ray Grid (Optional) - biodex 058-800 Instructions For Use Manual

Figure 2.8. The Drain Bag Holder and Flexible, Disposable Drain Bag Properly

Drain Pan (Optional)

The stainless steel drain pan and wire mesh screen are optional. To insert the drain pan, open
the vertical doors at the foot end of the table (the doors pivot toward the outside of the table.
Pull out on the drain pan support bars until they are fully extended. You can now place the pan
between the bars so that it is supported by the bars. Slide the pan along the bars until you feel it
drop into the notches. If desired, the pan can be stored in the table by simply pushing in on the
drain pan support bars.
Figure 2.9. The Drain Pan Properly Installed.

X-Ray Grid (Optional)

The optional, removable x-ray grid is 103 line, 8:1 ratio, 36" to 44" focal range grid. There is a
set of tracks about 1" above the film cassette tray tracks which holds the grid in the body of the
table. The grid can be inserted or removed from either side of the table.
To remove the x-ray grid, lift the grid up approximately 1/4" and then slide it out that side of
the table. To insert the grid, place the grid on the track with the center line of the grid running
"head to toe" and the center line facing upward. Insert the grid into the body of the table until it
Installed.
16