SERIAL # CLEAR
Executing this item makes the serial # in the EASY MENU disappear. It is impossible to display
the serial # again once you do this operation. Do not execute this item in any cases except when
you use the MAIN PCB taken from one projector for another in repair work.
NETWORK RESET
If this is executed, all of the network settings are initialized.
SOFT RESET
When this is executed, all of the user data is initialized. Never use it if not required.
11-2 RUN TIME window
The product operating time display method (accumulated light source hours display
method)
1. Open the ADVANCED MENU and select SETUP - LIGHT & FILTER - LIGHT SOURCE HOURS,
and then press the ►, ENTER or RESET button to display the LIGHT SOURCE HOURS reset
box.
2. Press the RESET button once, then press GEOMETRY button of the remote control for 3 seconds
or more to display the screen shown below. The menu will close after 55 seconds if there are no
further operations.
3. Use ▲/▼ buttons to select the usage status number. (The usage status is as shown below.)
RUN TIME window
LWU900-DS/LHD878-DS/LWU755-DS
Service Manual
LWU900-DS / LHD878-DS / LWU755-DS
← LIGHT SOURCE TIME
← LIGHT SOURCE TIME (CUSTOM)
← LIGHT SOURCE TIME (LIGHT 75%)
← LIGHT SOURCE TIME (LIGHT 50%)
← LIGHT SOURCE TIME (QUIET MODE)
← LIGHT SOURCE TIME (DIM)
← AC energizing time
← Number of times on
← Number of times off
← Usage status number
0 ..... Total usage status
1 ..... Current usage status
2 ..... Usage status before first reset
3 ..... Usage status before second reset
||
9 ..... Usage status before eighth reset
109
020-001586-01 Rev. 1 (02-2021)
LIT MAN SERV DS Series