Interacoustics Affinity Compact Instructions For Use Manual page 53

D-0123234-D – 2020/05
Affinity Compact - Instructions for Use - EN
Normal and reversed coordinate system buttons enable you to
toggle between reversed and normal graph.
Show curser on graph provides information about each specific
measured point in the curve. The curser is "locked" to the curve
and a frequency and intensity label will be displayed at the curser's
position, as illustrated below:
Stimulus Selection allows for selecting a test stimulus. The
dropdown is only present for custom made test protocols. The
standards (e.g. ANSI and IEC) have fixed stimuli.
Monitor: If you wish to listen to the amplified stimulus through a
monitor.
1. Connect a monitor headset to the monitor output on the
hardware.
2. Tick the Monitor check box.
3. Use the slider to turn the sound level up and down.
Current Protocol is listed in the lower left hand corner.
The indicates the test is a part of an automatic test flow (Auto
Run). When pressing START all tests with the tick mark will be
performed.
using the mouse by clicking on it. Then right
click at select Run this test.
Upon performing a test the system automatically jumps to the next
one in the test flow.
Colour indication shows the colour selected for each curve.
Test protocols can be created and adjusted in the HIT440 Setup.
Start/Stop button initiates and ends all tests.
Note that after pressing START the text on the button will
change to STOP.
If you wish to perform one test only, mark it
indicates that a curve has been measured.
Page 49