Installation Of A Battery Tray; 750 / 1200 / 1500 Battery: Installation And Connection - pellenc RASION 2 EASY Operating Instructions Manual

Lift the ejection flap (17) and slide the collecting bin (9)
into the notches located at the rear of the mower.
Note
Always check that the collecting bin is correctly attached to the lawn mower before you begin mowing.

4.3. INSTALLATION OF A BATTERY TRAY

As standard, the mower is equipped with the 750/1200/1500 battery support tray. To use an Alpha 260/520 type
battery, the factory-installed support tray must be removed and replaced by a suitable optional support.
Remove the 4 fixing screws of the pre-fitted battery tray.
Note
The Alpha 260 / 520 battery support is sold with the
harness.
Remove the battery holder from the harness before
installing it on the mower.
Fit the battery support tray on the chassis tube.
Fit and tighten the 4 fixing screws of the battery tray.

4.4. 750 / 1200 / 1500 BATTERY: INSTALLATION AND CONNECTION

Check battery life before use. If necessary, recharge the
battery using the charger supplied with the battery.
Slide the battery from the rear into the upper hook of the
battery tray (15).
Clip the front of the battery into the lower hook of the
battery tray (15).
Check that the battery is completely locked on the tray.
14
LAWN MOWER RASION 2 EASY
59_141654-B
59N_18_034
59N_18_036