Table of Contents
Advertisement
◊ PIVOTING THE SAW CARRIAGE
1. Loosen the handle at bottom of the column and turn the
handwheel on front to clear the blade of the table.
2. Disconnect the cutter head from the return spring.
3. Loosen lock lever, then pull back the lock knob.
4. Using the graduated scale as a reference, pivot the
saw carriage to one of the standard pre-set angles and
release the lock knob. Then retighten the lock lever.
Eyelet
Lock knob
Lock lever
5. Tighten the lock lever.
6. Make a kerf cut as explained in the previous section.
◊ GUIDE
Depending on the cuts to be made, it will be necessary to
adjust the guide to a given depth. 3 positions are possible.
For
rip
cuts,
pictograms of the graduated rule.
For crosscuts, adjust depending on the angle of the blade
and thickness of the cutting material.
Page 17
refer
to
the
Advertisement
Table of Contents
