Table of Contents
Advertisement
◊ SAW CARRIAGE RECOIL MECHANISM
1. Return the cutterhead assembly to rear of track arm.
2. Attach eyelet of cable assembly to carriage screw.
NOTE: To prevent premature wear of return reel cable,
position the return reel so that the cable does not rub
against the wall of the return reel
WARNING
!
Be sure that the machine is disconnected from
the power source.
◊ BLADE
1. Loosen the handle at bottom of the column and turn the
handwheel on the front to clear the teeth blade of the
table.
2. Remove the eyelet cable assembly of the carriage
screw and loosen the lock lever.
Carriage screw
Lock lever
Page 11
3. Move the carriage to the end of the arm and lock the
lever of step 2.
4. Loosen the lock handle
5. While lowering red handle, rotate the saw carriage to
the right. Release handle once the saw carriage is
positioned in front of you.
Advertisement
Table of Contents
