ComAp InteliGen 200 Operator's Manual page 27

Note: Use Left and Right button to move between digits.
Note: Enter invalid password to log out from controller.
Note: In case that invalid password is entered, the controller shows Invalid password screen. Use Page
button to go back to menu.
4.4 Lost Password
If you lost the administrator-level (level 3) password, proceed according to following steps.
1. Connect to the controller with InteliConfig, go to "Password reset" window and proceed according to the
instructions there. You will obtain unique one-time request code which must be sent to ComAp technical
support.
2. ComAp technical support will send an unique one-time action code to the backup e-mail address specified in
the controller.
3. Copy the received action code to InteliConfig and reset the administrator-level password to default.
IMPORTANT: It is extremely important to adjust the backup e-mail address in the controller.
Otherwise you will not be able to receive the action code!
IMPORTANT: If the backup email was not setup. Display the information screen containing the
serial number and password decode number as described in the chapter
29) and send them to your local distributor.
4.5 Password break protection
The controller password is protected against breaking by brute force. The protection works at every controller
interface separately.
InteliGen 200 Global Guide
Note: Use Up and
Down button to set
required value of
selected setpoint.
Information screen (page
27