Connect Cables; Operation; Check And Repair - Fastech Ezi-Servo Plus-R User Manual

1.5. Connect Cables

8
1.5 Connect Cables
Attention
Warning
1.6

Operation

Attention
1.7

Check and Repair

Warning
 Keep the rated range of Input Voltage for Ezi-SERVO. Otherwise, a fire or
other kinds of accidents may occur.
 Cable connection should follow the wiring diagram. Otherwise, a fire or
other kinds of accidents may occur.
 Before connecting cables check if input power OFF. Otherwise, an electric
shock or a fire may occur.
 The case of Ezi-SERVO is insulated from the ground of the internal circuit
by the condenser. Ground the Ezi-SERVO. Otherwise, an electric shock or
a fire may occur.
 If a protection function(alarm) occurs, firstly remove its cause and then
release(alarm reset) the protection function. If you operate continuously
without removing its cause, the machine get damaged or the user may get
injured.
 Do not make Motor Free and make input signal to ON during operation.
Motor will stop and stop current will become zero. The machine may get
damaged or the user may get injured.
 All parameter values are set by default factory setting value. Change this
value after reading this manual thoroughly. Otherwise, the machine may get
damaged or other kinds of accidents may occur.
 Stop to supply power to the main circuit and wait for a while before checking
or repairing the Ezi-SERVO. Electricity remaining in the capacitor may occur
danger.
 Do not change cabling while power is being supplied. Otherwise, the user
may get injured or the product may get damaged.
 Do not reconstruct the Ezi-SERVO. Otherwise, an electric shock may occur
or the reconstructed product can not get after service.
www.fastech.co.kr