Gateway Screen - Graco ProMix PD2K Operation

Gateway Screen

Screen
Gateway Gateway Screen
The Gateway screen sets the following system
operating parameters for the CGM protocol installed.
Figure 44 Gateway Screen
Gateway Gateway ID ID ID Gateway
Select the desired Gateway ID from the dropdown
menu.
3A4486D
Enable
Enable Enable
Uncheck Enable while setting the IP Address, Subnet
mask, Gateway, DNS1 or DNS2. When the settings
are loaded, check the Enable box to write the new
settings to the selected Gateway.
Check this box to enable the selected Gateway so
that the PLC can communicate with it.
DHCP DHCP DHCP
Select this box if your system has a Dynamic Host
Configuration Protocol (DHCP). This protocol assigns
unique IP addresses to devices, then releases and
renews these addresses as devices leave and rejoin
the network. If selected, the IP Address, Subnet, and
Gateway fields will not be editable and will display
the addresses supplied by the DHCP.
TCP/IP TCP/IP TCP/IP
Use the remaining fields to set the IP address, subnet
mask, Gateway, DNS1, and DNS2.
Setup Mode Screens
75