Dps Ii Specifications - Art DPS II User Manual

DPS II SPECIFICATIONS
Dimensions
Weight
Analog Input Connections
Analog Output Connections
Digital Input Connections
Digital Output Connections
Analog Input Impedance
Analog Output Impedance
Word Clock Specifications
Digital Level
Digital Output Specifications
Maximum Input Level
Maximum Output Level, XLR
Maximum Output Level, ¼"
CMRR
Frequency Response
Dynamic Range
Total Harmonic Distortion
Maximum Gain
Equivalent Input Noise (EIN)
Tube Type
Power Requirements
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.
XLR to XLR
Inst. to ¼"
XLR to ¼"
Inst. to XLR
XLR to XLR
Inst. to ¼"
1.75"H x 19"W x 6.5"D
5.5 lbs.
Front: XLR (balanced)/ ¼" (unbalanced)
Rear: Switchable XLR (bal.)/ ¼" TS,
XLR (balanced), ¼"TS,
ADAT Optical, Word Clock BNC
ADAT Optical/TOSLINK, S/PDIF RCA
XLR –150 to 3K Ohms, ¼" -1M ohm
XLR-300 ohms, ¼" -150ohms
BNC jack, 5V max.,
Ext. sync mode source
-∞ to +10dB
S/PDIF RCA 75 ohms, 0.5 Volt
+19dBu
+28dBu
+22dBu
>75dB (typical @ 1KHz)
5Hz to 50KHz, +0.5dB
>100dB
<0.01% (clean), <0.1%(warm)
80dB
68dB
74dB
74dB
-129dBu (A weighted)
-105dBu (A weighted)
12AX7A, Dual Triode, Hand Selected
USA – 110-125V AC / 50-60hz/ 16W export
units configured for country of destination.
- 19 -