Instructions For Requesting Spare Parts; Spare Parts; Changes And Manufacturing Of Spare Parts Without Approval; Liability Exclusion - OBL X9 Series Operating Manual

X9 Series metering pumps
2.3

INSTRUCTIONS FOR REQUESTING SPARE PARTS

Find and study the sectional drawing of the pump in use, if necessary contact OBL to obtain a copy. Analyze the conditions and identify
the damaged components. Using the nomenclature of the sectional drawing, make a list of the parts those components (mention the
sectional drawing number and the component position code) and send to the OBL Sales Office, always specifying:
type of metering pump (complete model number)
-
metering pump serial number
-
OBL job n° (as an alternative to the serial number)
GB
-
N.B.: These informations can be found on metering pump nameplate.
2.3.1

Spare parts

Standard components (screws, nuts, ball bearings, etc...) are also available directly from specialised dealers. Replace any other
components with original OBL spare parts.
2.3.2

Changes and manufacturing of spare parts without approval

Modifications ARE NOT allowed. Original OBL spares and accessories are to be used in order to assure the
conformity with safety rules. OBL declines any responsibility in case of use of non-original parts and warranty will be
no longer valid.
2.4

LIABILITY EXCLUSION

OBL is unable to monitor the observance of the instructions given in this manual, nor verify the actual working conditions and
installation of the equipment, the correct operation, the using and maintenance of the machines and accessories.
An incorrect installation, or misuse of the machine, may cause serious damage and may pose a danger to persons or property. Any
anomalies must be reported to the maintenance supervisor. The user is not authorized to tamper with the machine for any reason.
Attempts to disassemble, modify or tamper in general by unauthorized personnel will void the guarantee and
will release OBL from any liability for damage caused to persons or property resulting from such actions.
OBL is considered released from any liability in the following cases:
improper installation;
-
improper use of the machine by non-professional or inadequately trained operators;
-
use not in compliance with regulations in the Country of use;
-
lack of maintenance or improperly performed;
-
use of non-original spare parts or incorrect parts for the model in question;
-
total or partial failure to observe the instructions;
-
exceptional environmental events.
-
2.5

RESTRICTIONS REGARDING THIS DOCUMENT

This document is property of OBL S.r.l. together with the technical information contained in it. Modification, reproduction or copying (in
part or whole) without written permission is prohibited. Violations will be prosecuted by law.
3.

SAFETY WARNINGS

METERING PUMPS ARE INDUSTRIAL MACHINERY NOT INTENDED FOR USE BY NON-PROFESSIONAL
OPERATORS. THESE INSTRUCTIONS ARE INTENDED FOR QUALIFIED PERSONNEL.
FULLY AND CAREFULLY study these instructions before installing and starting the pump. Failure to respect
safety recommendations can damage the machine or compromise its operation.
For a correct handling and maintenance strictly follow present information. It is of key importance that these are read by the installer
and the maintenance supervisor. This document should be stored near the machine in a safe, dry place, and in any case always made
easily and readily available for future reference.
Keep always the instructions and warnings presents directly on the equipment in good and readable condition (replace
if necessary):
Equipment nameplate
•
Arrow indicating the motor direction of rotation
•
Page 6 Copyright © - OBL Metering pumps - All rights reserved
Operating manual
File: UT-4336 – Rev.0