Claypaky Hy B-Eye K15 User Menu
Hide thumbs Also See for Hy B-Eye K15:

Advertisement

Note: Default parameters Highlighted in grey.
Main Menu
Basic Engine
Pixels Engine
S
U
ET
P
Repeat on DMX
Ethernet Interface
Hy B-Eye series – User Menu
Hy B-Eye K15
Hy B-Eye K25
Level 1
DMX Address
DMX Address
Enablement
Control Protocol
Custom IP Address
Custom IP Mask
Fixture ID
Level 2
Mode
Source
Universe
Mode
Source
Universe
Universe
IP address byte 1
IP address byte 2
IP address byte 3
IP address byte 4
IP mask byte 1
IP mask byte 2
IP mask byte 3
IP mask byte 4
User Menu
Level 3
Choices / Values
Standard
Standard + Freq.
Shape + Freq.
Disabled
Kling-Net
Disabled
Enabled on primary
Disabled
Art-net on IP 2.x.x.x
Art-net on IP 10.x.x.x
Custom IP
01/2020
1
Shape
DMX
Art-net
0 - 255
1 - 512
RGB
RGBW
DMX
Art-net
0 - 255
1 - 512
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hy B-Eye K15 and is the answer not in the manual?

Questions and answers

Summary of Contents for Claypaky Hy B-Eye K15

  • Page 1 Hy B-Eye K15 User Menu 01/2020 Hy B-Eye K25 Note: Default parameters Highlighted in grey. Main Menu Level 1 Level 2 Level 3 Choices / Values Standard Shape → Mode Standard + Freq. Shape + Freq. Basic Engine → Source Art-net →...
  • Page 2 Main Menu Level 1 Level 2 Level 3 Choices / Values → Invert Pan On / Off → Invert Tilt On / Off → Swap Pan-Tilt On / Off → Encoder Pan-Tilt On / Off Standard → P/T Homing mode Sequenced 0 degree Pan / Tilt...
  • Page 3 Main Menu Level 1 Level 2 Level 3 Choices / Values Normal → Pan/Tilt speed Fast Curve 1 Curve 2 → Dimmer curve Curve 3 Curve 4 Gamma 1.0 → RGB Gamma Gamma 1.5 Gamma 2.0 Halogen OFF Halogen Lamp 1 Halogen Lamp 2 →...
  • Page 4 Main Menu Level 1 Level 2 Level 3 Choices / Values → → System Errors Read / Reset → Total Hours Read Fixture Hours → Partial Hours Read / Reset → Total Hours Read LED Energy Tot → Partial Hours Read / Reset →...
  • Page 5: Setup Menu

    SET UP MENU For greater programming ease using the DMX control Per una maggiore comodità in fase di programmazione unit Media-server Art-net, channel mapping tramite centraline di controllo DMX e Media-server Art-net divided into BASIC ENGINE and PIXEL ENGINE (see la mappatura canali è...
  • Page 6 SET UP MENU Setup – Pixel Engine – DMX ADDRESS It lets you select the address (DMX Address) for the Permette di selezionare l'indirizzo (DMX Address) per il control signal by PIXELS ENGINE. A DMX address segnale di controllo della parte relativa al PIXELS between 001 and 512 can be selected.
  • Page 7: Option Menu

    OPTION MENU Option - PAN / TILT INVERT PAN INVERT PAN Permette di abilitare (ON) l’inversione del movimento Pan. It lets you enable (ON) Pan reverse movement. Select OFF to turn off or disable this option. Selezionare OFF per non abilitare o disabilitare questa opzione.
  • Page 8 OPTION MENU Option – SILENT MODE Permette di selezionare uno dei tre “Silent mode” It allows you to select one of the three Mode available: • Standard: Cooling is at its maximum and noise too, than disponibili:  the derating occurs late. Standard: la ventilazione è...
  • Page 9 OPTION MENU Option – SPECIAL FUNCTIONS PAN/TILT SPEED PAN/TILT SPEED Lets you select two different Pan and Tilt speeds: Permette di selezionare due differenti velocità di  movimento di Pan e Tilt: Normal   Normal Fast  Fast DIMMER CURVE DIMMER CURVE Permette di selezionare quattro differenti curve del canale Lets you select four different Dimmer channel curves (see...
  • Page 10 OPTION MENU PWM Frequency PWM Frequency Lets you select ten different base frequencies of LEDs: Permette di selezionare la frequenza base di lavoro dei LED:   1000Hz 1000Hz   1500Hz 1500Hz   2400Hz 2400Hz   3700Hz 3700Hz ...
  • Page 11: Information Menu

    INFORMATION MENU Information - SYSTEM ERRORS It displays a list of errors that occurred when the projector Mostra una lista di errori verificatisi dall'accensione del was turned on. proiettore. To reset the SYSTEM ERRORS list, press OK. A Per resettare la lista dei SISTEM ERRORS premere OK, confirmation message appears (Are you sure you want to sul display appare un messaggio di conferma (Are you clear error list?).
  • Page 12 INFORMATION MENU Information - BOARD DIAGNOSTIC It lets you view the percent errors for each electronic Permette di visualizzare la percentuale di errore di ogni board installed in the projector scheda elettronica installata nel proiettore   0: P&T (Pan / Tilt board) 0: P&T (Pan / Tilt board) ...
  • Page 13: Manual Control Menu

    MANUAL CONTROL MENU Manual Control - RESET It lets you reset the projector from the projector control Permette di eseguire il reset del proiettore dal pannello panel. comandi del proiettore stesso. Manual Control - CHANNEL It lets you set the channel DMX levels from the projector Permette di impostare il livello DMX dei canali dal pannello control panel (value between 0 and 255 bit or between 0% comandi del proiettore (valore compreso tra 0 e 255 bit...
  • Page 14: Advanced Menu

    ADVANCED MENU To open the “Advanced Menu”, enter the code (1234). Per accedere al "Menu Advanced" impostare il codice (1234). Advanced – ZOOM REPOS Allows you to enable (On) or disable (Off) the coming back Permette di abilitare (On) o disabilitare (Off) il rientro del of the lens gruppo lenti assembly (channel Zoom @ 255bit), in the absence of...

This manual is also suitable for:

Hy b-eye k25

Table of Contents