Section 8.6: Ip Mode (Switches 19 And 20); Chapter 9: Area Adjuster - Nabco Acusensor M Installation Manual

www.NabcoEntrances.com
Rev 8-25-17
Sensitivity
17 18
(Super High)
SECTION 8.6: IP Mode (Switches 19 and 20)
Attention: DO NOT use Acusensor M with Acusensor 3 within the same Presence Detection Area. IP Mode
may not work properly. Replace Acusensor 3 Sensors with Acusensor M Sensors.
Attention: Interior side Sensor and exterior side Sensor must have different IP mode setting.
IP Mode is utilized when Sensors are placed within the same Area and/or when Sensors are facing each other. This is true for multiple
Acusensor M Sensors and/or older versions of the Acusensor, Acuvision, and/or Acumotion sensors.
Table 18 IP Mode
To prevent Sensor Malfunction, the IP Mode Setting must be different from that on each other sensor.
IP Mode
19 20
CHAPTER 9: AREA ADJUSTER
Counter Clockwise to adjust the Detection Area Pattern farther out.
The Area Adjuster is a Phillips Head screw that the installer turns to angle the Sensor:
Clockwise to adjust the Detection Area Pattern farther in.
X
X
An Angled Spacer (sold separately) can be used to provide a Presence Detection Area outside of normal Depth.
1. Turn OFF power.
2. Go to Area Adjuster located on the Right hand side of Acusensor M.
DN 1565
SH X 98" thru 118" (2.5m thru 3.0m)
X Use if sensitivity is too LOW with Switch Setting (H)
A Default for the Acusensor M
B Suggested IP Mode for 2nd Sensor
C Suggested IP Mode for 3rd Sensor
D Suggested IP Mode for 4th Sensor
Degree Indicator Charts
Depth Learn Time Anti-Noise Anti-Environment Sensitivity IP Mode
9 10 11 9 10 11 12 13 14 15 16 17 18 19 20
6 2 30s Normal Normal H
5 5-6eco 15s Special Anti-Vibration M
4 4-6eco 60s Anti-Snow I L
3 Area Check 300s Anti-Snow II SH
Mounting Height
0
A
B
C
-10
Area Adjuster
D
AcusensorMInstallationManual
Description
Degree Indicator
Figure 10 Area Adjuster
P/N C-00187
Area Adjuster
19 of 28