Section 7.3: Input Logic (Switch 4); Section 7.4: Width Setting (Switches 5 Thru 8) - Nabco Acusensor M Installation Manual

www.NabcoEntrances.com
Rev 8-25-17
In the event a Self Diagnostic Error occurs, the door will not open. Instead the Sensor LED will illuminate a blinking Red Light (1Hz)
indicating an Error.
SECTION 7.3: Input Logic (Switch 4)
Table 7 High Setting vs Low Setting
Note: Ensure both the Acusensor M and the Control is set for N.O. or N.C.
Input Logic
4
High +input
- input
X U30 FUNCTION (6) setting should be No
X Opus setting should be "Sensor Monitoring N.O. (Normally Open)
Low +input
- input
X U30 FUNCTION (6) setting should be "Yes".
X Opus setting should be "Sensor Monitoring N.C. (Normally Closed)
SECTION 7.4: Width Setting (Switches 5 thru 8)
Table 8 Presence Detection Area
Note: On swing and fold doors, set width pattern as narrow as needed to avoid detection of the door in the open position.
Width (L)
5 6
= Active Area Left Side
6
5
4
3
Connects to +voltage
Connects to Output, regardless of Switch 4 Setting.
Connects to +voltage
Connects to Output, regardless of Switch 4 Setting.
Description
Width Area Diagram
= Inactive Area
AcusensorMInstallationManual
= Active Area Right Side
P/N C-00187
Width (R)
7 8
6
5
4
3
13 of 28