Chapter 8: Switch Settings 9-20 - Nabco Acusensor M Installation Manual

Acusensor M Installation Manual
P/N C-00187
CHAPTER 8: SWITCH SETTINGS 9-20
1. Turn OFF power.
2. Lift the reusable protection flap located on the Left hand side of Acusensor M.
a. Underneath the flap are three groups of Switches.
DN 1562
3. Go to the middle of the Acusensor M to locate a diagram for how to set switches 9 thru 20.
# Default Se ng IP Mode Interference Protec on
Depth
9 10 11 9 10 11
#6
5
4
3
Depth
Learn Time
Anti-Noise
Anti-Environment
Sensitivity
IP Mode
14 of 28
Learn Time
12 13
2 #30s
5-6eco 15s
4-6eco 60s
Area 300s
Check
Adjusts depth of Presence Detection Area (grid)
The amount of time it takes for the sensor to learn the area, or relearn if a normally stationary
object is moved. ANSI requires minimum 30sec.
Helps prevent false detection caused by electrical noise or nearby light sources.
Helps prevent false detection caused by vibration, insects, snow.
Adjust signal strength for detecting moving pedestrians or objects. Example: For slow moving
pedestrians or objects, sensitivity option should be on Medium or High.
Helps prevent interference caused by sensors near each other.
Depth Learn Time Anti-Noise Anti-Environment Sensitivity IP Mode
9 10 11 9 10 11 12 13 14 15 16 17 18 19 20
6 2 30s Normal Normal H A
5 5-6eco 15s Special Anti-Vibration M B
4 4-6eco 60s Anti-Snow I L C
3 Area Check 300s Anti-Snow II SH D
Switches 17-20
Switches 9-16
Switches 1-8
Anti-Noise Anti-Environment Sensitivity IP Mode
14 15 16
#Normal #Normal
Anti-Vibration
Special
Anti-Snow I
Anti-Snow II
www.NabcoEntrances.com
Figure 7 Switch Settings
17 18 19 20
#H #A
M B
L C
SH D
Figure 8 Switch Setting Diagram
Rev 8-25-17
DN 1563