Bras B-express Operator's Manual page 14

EN GLIS H
B - E X P R E S S
5. 6 WATER FILTER
The dispenser has a water filter on the tank suction pipe. This
component descales the water, i.e. retains calcium in the water
used to prepare the drinks. It should be replaced after a certain
number of dispensing operations, otherwise it will lose its
descaling capacity and this can result in damage to the internal
parts of the dispenser. A filter lifespan counter can be set that
counts down with each dispensing operation and, when it
reaches zero, this message appears on the display:
REPLACE
WATER FILTER
To cancel this message and restore normal operation, you need
to replace the filter with a new one and then press the FILTER
RESET (4) key for five seconds.
6 CLEANING AND SANITIZING PROCEDURES
Cleaning and washing the appliance are vital to guarantee
perfect preservation of flavour of the drink and maximum
efficiency of your dispenser. The procedures described below
must be considered of a general nature and may vary owing to
the applicable health and safety regulations in force.
6. 1 DISASSEMBLY
ATTENTION
Before disassembling any component, always unplug
the device from the mains or turn off the external wall
switch.
1 Remove the drip tray and empty it.
2 Remove the dispensing nozzles.
3 Remove the front cover.
4 Remove the powder containers from the dispenser.
5 Disassemble the mixers as follows (see figure 8):
A Turn the steam suction collar clockwise to release the suction
pipe from its seat. Pull the powder collection funnel upwards to
release it from the mixing chamber and then pull it outwards to
remove it.
B Turn the body of the mixer to release it from its base and pull
it outwards to remove it.
C Remove the rotating part of the mixer releasing it from the
motor shaft.
D Turn the base assembly of the mixer to release it from the
retaining pins and pull it outwards to remove it.
6. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1 Prepare at least one litre of a mild cleaning solution of warm
(45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3 Rinse all cleaned parts with cool clean water.
14
figure 8