Daiichi Electronics SMLC-110L Instruction Manual page 34

(2) 221A to 225A Analog output setting 【With an analog output option】
Various setting of analog output is performed.
221A RESET/
Ao1 output factor SHIFT
RESET/
SHIFT
◆ 221A to 224A AO(analog output)1 to 4 output factor.
Set the output factor of each analog outputs.
Selection by ＋ and － , set value is updated by SET .
V(RS)，V(ST)，V(TR) becomes only phase voltage input product.
Default setting：AO1 MVo
AO2 V(RS)
AO3 V(ST)
AO4 V(TR)
OFF：
Nothing
9：Hz
◆ 225A Low input cut
This function which makes analog output a lower limit at the case of a
minute input. A function can be selected from ON (Use) and OFF (Non use).
However, in case an output is frequency, a low input cut is not done.
Selection by ＋ and － , set value is updated by SET .
Default setting：OFF (Non use)
Cut value
Zero-phase voltage：Full scale 1.0％ or less.
Voltage：Full scale 0.5％ or less.
222A RESET/
Ao2 output factor SHIFT
225A RESET/
Low input cut
SHIFT
1：MVo 2：Vo
8：V(TR) 7：V(ST)
223A
Ao3 output factor
RESET/
SHIFT
224A
Ao4 output factor
3：V(RN)
6：V(RS)
Setting factor
33
SMLC-213-154
New setting
Setting No.
Current setting
Ao1 output factor
4：V(SN)
5：V(TN)
New setting
Setting No.
Current setting
Low input cut