Table of Contents
Advertisement
Model and Serial Number
Attached to the frame is an ID plate showing the serial number. Record your implement information
and serial number in the space provided below. ABI will use this information to give you prompt, effi-
cient service when you order parts.
Size: ___________________________________
Serial number: ___________________________
Invoice number: __________________________
Purchaser's name: _________________________
Preparation
1.
Before operating equipment, read and understand the operator's manual.
2.
Thoroughly inspect the implement before initial operation to assure that all packaging materials, i.e., wires,
bands, and tape have been removed.
3.
Personal protection equipment including safety glasses, safety shoes, and gloves are recommended during
assembly, installation, operation, adjustment, maintaining and/or repairing the implement.
4.
Operate the implement only with a tractor equipped with an approved Roll-Over-Protective-System (ROPS). 5.
Always wear your seat belt. Serious injury or even death could result from falling off the tractor.
5.
Operate only in daylight or good artificial light.
6.
Ensure the implement is properly mounted, adjusted and in good operating condition.
7.
As with all arena dragging equipment, always ensure footing material in the arena is at a consistent depth, if
an arena base is installed, before engaging subsurface implements. If the footing layer depth is not
consistent, you could damage your arena base layer. See page 9 for details.
8.
Double check implement depth into the footing to ensure it will NOT go below the footing layer into the base
layer of the arena. (If base exists) This double check must be completed upon entering the arena and agai
after pulling forward a short distance, to remove any slack from pins and linkages, after each time the
implement or linkages are adjusted.
9.
The TR3 E-Series may slightly settle (½") into footing material, after an initial pass over compacted materi
has been loosened, requiring adjustment to ground engaging components to prevent damage to the base
layer of an arena.
Starting and Stopping
1.
Be sure that no one is near the machine prior to engaging or while the machine is working.
2.
Be sure the tractor is in neutral before starting the engine.
3.
After striking an obstacle, shut the tractor off, remove key and thoroughly inspect for damage before
restarting.
2
Safety Precautions
© Copyright 2018 ABI Attachments, Inc.
Advertisement
Table of Contents
