Page 1
Instructions manual MIF-3600/01-I [05-2008] Vertical pumps for tanks vortex impeller This manual contains important instructions and warnings. You must read them before mounting, making the electrical connections and starting up. You must also comply with the instructions for the components related to this pump. You should also remember that it is essential to keep this Manual close to the motor pump equipment.
Index 1 GENERAL ..............3 7 MAINTENANCE/CONSERVATION......7 7.1 G ........... 7 ENERAL INSTRUCTIONS 2 SAFETY ..............3 7.2 M ........8 AINTENANCE INSPECTION 2.1 M ..... 3 7.2.1 Checking instructions ........8 ARKING OF WARNINGS IN THIS MANUAL 2.2 P ..
Personal hazard resulting from electrical, mechanical or spare parts. chemical effects. If you require any additional information or have problems with Danger to the environment due to escaping noxious regards to failures, please contact the nearest KSB ITUR products. service. Conscientious safety at work Safety...
The weight is generally Form of construction shown on the delivery note or on the data plate. If it is not, and the equipment cannot be handled safely, please contact KSB Spiral pump casing with axial suction and radial impulsion. ITUR.
The suction and impulsion flange covers of the pump must be other parties. KSB ITUR only offers details and comments as removed before connecting the pipes. a help, but does not assume any responsibility with regards to the design, assembly and operation of any installation.
Electrical connection: 5.4.2 Time relay adjustment In the star-triangle start-up of three-phase motors, it is The electrical connection must be carried out by a necessary to ensure that the switching from star to triangle specialist electrician! Applicable regulations must be takes place quickly.
6.1.3 Final control Service limits Make the final check of the group alignment in accordance 6.2.1 Switching frequency with 5.2. The coupling/shaft must allow easy manual rotation. In order to prevent abnormally high temperatures and Check all the auxiliary connections are overloading of the motor, pump, coupling, seals, etc, the Note correct and functioning.
1. Lubricated with pumping fluid: If the pumped fluid is clean Maintenance/inspection (without particles in suspension) and non-aggressive, the 7.2.1 Checking instructions friction bearings are lubricated with the pumped fluid. Lubricant is not required. During the first minutes of operation: 2.
DISMANTLING: 7.5.3 Tightening torque of the screws/nuts As a general guide to dismount the equipment, follow these Stainless steps: Steel steel Tightening Torque in [N·m] ISO Metric Release the coupling if it is of rigid type. (for non-lubricated thread) thread Release the attachment screws and remove the motor.
Trouble-shooting The pump does not move the fluid | Insufficient pressure or flow | | Excessive absorbed power | | | Excessive vibrations and noise | | | | Excessive support temperature | | | | Cause Solution Open them or search for a work point with the impulsion Impulsion valves closed or poorly regulated valve Incorrect rotation direction...
Page 16
This warranty will be reduced to 6 months for continuous or permanent service pumps. KSB ITUR Spain, S.A. shall not be liable for any direct or indirect damage which the product suffers as a result of defective installation, lack of maintenance, negligent handling, handling by unauthorised personnel, overloading or deficient functions.
Need help?
Do you have a question about the ITUR IFV-32 and is the answer not in the manual?
Questions and answers