Cleaning, Care And Maintenance; What To Do If; The Appliance Develops Faults - STIEBEL ELTRON SH 50 A Operation And Installation

OPERATION

CLEANING, CARE AND MAINTENANCE

5. Cleaning, care and maintenance
Never use abrasive or corrosive cleaning agents. A damp cloth
»
is sufficient for cleaning the appliance.
Check the taps regularly. You can remove limescale deposits at
»
the tap outlets using commercially available descaling agents.
Have the electrical safety of the appliance and the function of
»
the safety assembly regularly checked by a heating contractor.
Have the protective anode checked by a heating contractor after
»
the first two years. The heating contractor will then determine
the intervals at which it must be checked thereafter.
6.

What to do if ...

6.1

... the appliance develops faults

Fault Cause
The water does not heat There is no power.
up.
The outlet flow rate is The perlator in the tap or
low. shower head is scaled up
or dirty.
If you cannot remedy the fault, notify your contractor. To speed
your enquiry, please provide the serial number from the type plate
(no. 000000-0000-000000):
SH 80 A Nr.: 000000 - 0000 - 000000
80 l St em 0,6 MPa (6 bar) 18 l/min
2 kW 1/N/PE ~ 230 V
50 Hz
Made in Germany
[
18 |SH A
» Remedy
Check the fuse/MCB
in your fuse box/
distribution panel.
Clean and/or descale the
perlator or shower head.
SH 80 A Nr.: 000000 - 0000 - 000000
80 l St em 0,6 MPa (6 bar) 18 l/min
2 kW 1/N/PE ~ 230 V
50 Hz
Made in Germany
WWW.STIEBEL-ELTRON.COM