Wilson Electronics weboost Drive Reach RV Installation Overview page 2

STEP 1: Mount Outside
Antenna & Route Cable
Determine where you want the Outside
Antenna on your RV. Mount the Outside
Antenna to a ladder or pole so that the
entire Outside Antenna is above the roof
line of the RV. Route 25' RG-6 cable from
inside RV to Outside Antenna.
NOTE: L-Bracket Pole Mount and
Side Exit
Adapter
hardware is provided. If installing with
Spring, the Side Exit Adapter must
be used.
Spring
(optional)
L-Bracket Mount &
hardware
STEP 2: Connect Cable
common Outside
Antenna mounting
location To Outside Antenna
After routing the RG-6 Cable into the
RV, connect the cable to the
Outside Antenna.
STEP 3: Inside Antenna
Location
ladder rail
Place Inside Antenna where stronger
signal is desired in the RV.
STEP 4: Booster Location
Outside Antenna
& Connect Cables
Find a location to place the Drive Reach
Booster and secure it with provided bracket.
Connect cable from Outside Antenna to
labeled booster port and connect cable from
Inside Antenna to labeled booster port.
RG-6
Cable
STEP 5: Connect Power
Supply To Booster
Inside Antenna
Connect the power supply cord to the
end of the booster, labeled "
connect into a 110V wall plug. Enjoy your
boosted signal!
from Inside
Antenna
®
from Outside
Antenna
", and
Refer to Installation Guide for Detailed Instructions.
Booster