Disconnect Commands; Status Commands - AMX Precis LT User Manual

Generating Commands (Execute, Disconnect, Status)
Example: CI2O3T Change on both levels, (I2O3) Input 2 to Output 3, (T) Take to
execute the command.

Disconnect Commands

Disconnect command lines begin with "D" and specify an input or output, followed
by the Take command.
Example: DL2O3T (DL2) Disconnect on Level 2, (O3) Output 3, (T)Take to
execute the command.
ä To designate multiple inputs or multiple outputs, insert a space between each
number.
ä A command line cannot contain both multiple inputs and multiple outputs.
ä Disconnecting one output does not affect any other outputs routed to the same
input. Disconnecting an input disconnects all outputs receiving that input signal.

Status Commands

Status command lines begin with "S" and follow the same format as Disconnect
commands. The result appears in parenthesis ( ).
Example: SL2O3T (SL2)Status on Level 2, (O3) Output 3, (T) Take to execute
the command.
The Status command can verify signal status to confirm that a switch has executed
correctly or that a signal has correctly routed to multiple outputs.
ä An input can route signals to one or more outputs. Verifying input status shows
all outputs.
ä An output can receive a signal from only one input at a time. Verifying output
status shows the one input. Output status will not show other outputs also
receiving the same input.
In a Status command, the routing of a signal can be verified on both levels or on a
single level. To verify on both levels, omit the level command. To verify video
signals, enter Level 1. To verify audio signals, enter Level 2. If a signal is only
routed on one level, checking the status on both levels will show the signal as not
routed.
43 BCS Serial Control Protocol