Stereo Audio 3-Term & 5-Term
Stereo Audio 3-Term
To attach stereo audio input and output wires:
1. Unscrew the clamps on the audio connector.
2. Insert the wires (see Figure 13 for wire placement for single-ended stereo) and
firmly re-tighten the clamps to make secure connections.
Figure 13: Insert the wires and re-tighten clamps
Stereo Audio 5-Term
To attach stereo audio input and output wires:
1. Unscrew the clamps on the audio connector.
2. Insert the wires (see Figure 14 for wire placement for balanced and unbalanced
audio) and firmly re-tighten the clamps to make secure connections.
Figure 14: Balanced audio
Note: When using twisted pair wire, connect the shield (ground) at one end only
(recommend receiving end) to minimize low frequency noise (see Figure 12).
12
Unbalanced audio
Installing the Precis
LT