AMX Precis LT User Manual page 24

3. Open HyperTerminal. Check to be sure the Communication Port option is set
for the port that the null modem cable is plugged into and that the settings
match those in the Port Settings table below.
4. Apply power to the Precis
The HyperTerminal splash screen displays information* for your Precis
(see Figure 18).
Precis 1 RU vX.Y.Z
FP vA.B.C
Figure 18: Typical startup splash screen in HyperTerminal
Note: Each system ships from the factory with a default switch that automatically
routes Input 1 to all outputs the first time power is applied. While this is not reflected
in HyperTerminal, the signal from Input 1 is routed to all outputs.
5. Perform the test switch sequence on page 17 to clear the factory default switch
and to ensure the Precis
The only baud rate the Precis
controlling the system with a PC, use serial communication
software and make sure the PC's port settings match those
LT
in the Precis Serial Port Settings table.
* AutoPatch reserves the right to change the contents and/or formatting of the splash
screen at any time, without notice.
LT
according to the instructions on page 16.
Precis Version
Front Panel Version
LT
is working correctly.
LT
accepts is 9600. When
Installing the Precis
Precis
Serial Port Settings
Baud
Data Bits
Stop Bit
Parity
Flow Control
LT
LT
model
LT
9600
8
1
None
None
15