Test Mode - Honeywell ESSER 8010 Operation And Installation Instructions Manual

2.6

Test mode

The automatic zones no. 1 - no. 8 can be switched to Test mode via the function keys and the ten-button
keypad of the control panel.
Unlocked
In operation
Example: Test mode
In operation
Extinguishing system
activated
Extinguishing system
enabled
Zone
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Fig. 11: Indication and Operation – Switching on Test mode for detector zone No.6
The zone input in Test mode is indicated in the zone display with a yellow/red flashing LED. The yellow LED
>Test Mode< also lights up to indicate that the zone display is showing the status of the detector zone.
Example: Test mode
In operation
Extinguishing system
activated
Extinguishing system
enabled
Zone
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Fig. 12: Indication and Operation – Switching off Test mode for detector zone No.6
FB 798955.GB0 / 09.07
For operation, it is necessary to enable the keypad via the key-switch.
Switching on for zone No.6
Test operation
6
Switching off for zone No.6
On
6
Extinguishing Control Computer 8010 – 19-Inch
In operation
Extinguishing system
activated
Extinguishing system
enabled
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
activated
Extinguishing system
enabled
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Detector zone
1 2 3 4 5 6 7 8
9 10 11 12 13
Fire/Switch off/Trouble
Detector zone
1 2 3 4 5 6 7 8
9 10 11 12 13
Fire/Switch off/Trouble
15