Resetting The Panel; Lamp Test - Honeywell ESSER 8010 Operation And Installation Instructions Manual

2.8

Resetting the panel

The Panel can be reset via the function key of the control panel. For operation, the keypad must be enabled via
the key-switch. To restart the system press the appropriate button. The internal panel status and all visual
displays will be resetted.
Unlocked
In operation
A restart of the system does not take affect on disconnected detector zones or detector zones in
the test mode. This zone will not be switched on or resetted by a restart.
In operation
Extinguishing system
activated
Extinguishing system
enabled
Panel reset
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Fig. 15: Operating example – panel reset
2.9

Lamp test

The lamp test can be carried out via the keypad. All visual displays of the control panel lights up and the control
panel buzzer is activated until the key is released.
Unlocked
In operation
In operation
Extinguishing system
activated
Extinguishing system
enabled
Emergency release
Lamp test
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Fig. 16: Indication and Operation – Lamp test
FB 798955.GB0 / 09.07
Extinguishing Control Computer 8010 – 19-Inch
For operation, it is necessary to enable the keypad via the key-switch.
For operation, it is necessary to enable the keypad via the key-switch.
Detector zone
1 2 3 4 5
9 10 11 12 13
Fire/Switch off/Trouble
Common trouble
6 7 8
Emergency
operation
Power trouble
Battery trouble
Ground fault
Trouble 1
Blocking
Fan trouble
17