Honeywell ESSER 8010 Operation And Installation Instructions Manual page 52

Extinguishing Control Computer 8010 – 19-Inch
Low-voltage Relay
Relay 1
Relay 2
Relay 3
Relay 4
Relay 5
Relay 6
Relay 7
Relay 8
Relay 9
Relay 10
Relay 11
Mains voltage Relay
Relay 12
Relay 13
F10
F14, F15
J1 to J4, J6,
J8 to J13, J18
J5 (Relay 11)
J7 (Relay 10)
Poti
X47
X57
X11 / UB
EXT
52
FuseF16
FuseF13
FuseF12
FuseF11
FuseF9
FuseF8
FuseF6
FuseF5
FuseF2
FuseF3
FuseF4
FuseF1
FuseF7
Fuses of the supply voltage for external units, UBext, T 3,15 A / 250 V
Fuses of the emergency power supply (battery 1 + 2)
Battery 1: F14,
Battery 2: F15,
Jumpers to program the operating mode for relay 1 to 8, selectable to
monitoring or dry contact.
Factory setting = monitored relay
Jumper to set the CPU-failure-mode function for relay 11 >Emergency operation fault<
Inactive = CPU-failure-mode function deactivated (factory setting)
Active = CPU-failure-mode function activated
Jumper to set the CPU-failure-mode function for relay 10 >Emergency operation fire<
Inactive = CPU-failure-mode function deactivated (factory setting)
Active = CPU-failure-mode function activated
Potentiometer for adjusting the battery charging voltage 27.5 V DC (@ 25°C)
Terminal for the ribbon cable to the zone board
Plug for PE connection to the housings rear side
Terminals for the Supply voltage for external units +24 V DC / GND
(factory setting)
T2 A /250 V
T2 A /250 V
T3,15 A /250 V
T 3,15 A / 250 V
T 3,15 A / 250 V
Monitoring
or
dry contact
Contact rating
30 V DC / 2 A
dry contact
Contact rating
dry contact
230 V AC / 2 A
FB 798955.GB0 / 09.07