Verifying Signal Routing Status - AMX Precis Installation & Operation Manual

3.2 Verifying Signal Routing Status

Signal status can be verified to confirm that a switch has executed
properly or to confirm correct routing to multiple destinations.
You can put the Precis Remote in Status mode by pressing the Status
key. The panel remains in Status mode (with the Status key illuminated)
until you press the Cancel key.
While in Status mode, you can select different levels, sources, and
destinations at any time without affecting signal routing.
To verify signal status:
1. Press the Status key to put the Precis Remote in Status mode.
The Status key illuminates and all other lights on the panel turn off.
2. Press a Level key to select a level.
The Level key illuminates.
If you do not select a level, the system uses the level associated with
the All Level key. (The default level for that key is video and audio.)
3. Press a Source or Destination key to select a source or destination.
If you press a Source key, that key illuminates and the Destination
key(s) receiving the source signal also illuminates to show the
routing status of the signal.
If no Destination keys illuminate, the signal is not routed or is not
available on that level.
If you press a Destination key, that key illuminates and the Source
key routed to it also illuminates, showing which source is currently
routed to that destination.
If no Source key illuminates, the signal is not routed or is not
available on that level.
Checking the status of a destination does not show other destinations
connected to the same source. To check the status of a signal routed to
multiple destinations, select the source first.
Precis Remote X/Y Control Panel
Verifying Signal Routing Status
3-3