Lcd Display Settings; Alarm Settings - GSE 16A Manual

Go to the menu "Set photosensor". This is used for day> night or night> day change over.
Depending on the state day or night, the controller selects the appropriate settings you have set
previously in the controller. Here you will see the current value of the light sensor, this occurs in
daytime almost 100%. As darker it is, as lower is this value. Set the switching threshold. press again
ENTER the value begins to blink, change the value with UP / DOWN buttons and save with SAVE /
EXIT to return to the light sensor menu. Now select the "Switch time". The switching time is a time
delay which starts a count down after reaching the light sensor level. During this time the switching
threshold remains. Only after expiration of the delay time, the controller will perform the switching
threshold. If this time gets interrupted, the time delay starts to count down again from beginning.
This function is used to prevent an immediate change over e.g: A door gets opened briefly. Press
ENTER, the value starts to blink, change the value with UP / DOWN save it with SAVE / EXIT.
EN

LCD Display settings:

Go to the sub menu "Set display" this is used to change the state of the LCD back light. You have the
choice of Automatic, on or off. Change the value with UP / DOWN buttons and save it with SAVE /
EXIT.

Alarm settings:

Here you can set the maximal and minimal alarm values of the sensors. In case of an over or under
cut of the set value you will receive an alarm message on the 9. Alarm LED on the foil. Depending on
the model you have there is a free contact in the inside of the controller which is closed by alarm.
You can read the alarm in the main screen part 3 and confirm it with SAVE / EXIT button. Should the
measured value still exceed the set alarm value than the alarm get immediately activated again.
Go to the menu "Set alarm". Choose the sensor and confirm with ENTER, choose now the alarm
value with UP / DOWN buttons. Push the ENTER button to change the value with UP / DOWN
buttons, save it with SAVE / EXIT button. Repeat this this procedure to change all the other alarm
values.
28
16A Fan controller
LCD back light
automatic
Sensor T1 temperature
Max.temp. 32.3C
Min.temp.-12.6C
Sensor R1 humidity
Max.humidity 60
Min.humidity 10
Sensor T2 temperature
Max.temp. 32.3C
Min.temp.-12.6C
on
off
◦
◦
%
%
◦
◦