Output Sensor 1 Cool; Output Sensor 1 Humidify/Moisturise; Output Sensor 1 Dehumidify/Drying; Output Sensor 2 Heat - GSE 16A Manual

Heat day = Heater temperature by day time
Heat night = Heater temperature by night time
Hyst. = Hysteresis setting
Select e.g: "Heat day" here you can adjust the temperature on the day time. Proceed as usual,
pressing ENTER the value starts to blink, change the value with UP / DOWN buttons, you can store
the value with SAVE / EXIT. Go to the next setting "Heatnight" and repeat the procedure.
The hysteresis determines the quiescent condition of the contact. e.g: If the hysteresis is set to -
2.0°C and a set value to 24.0°C, then the heater will at 24.0°C - 2.0°C = 22.0°C and among switch
on and reaching the value of 24.0°C switch off again. This contact will remain off until the value
EN
again drops below 22.0°C.

Output sensor 1 cool:

The procedure is the same as in "Output Sensor 1 heat" only the hysteresis works in reverse mode
during the cooling. e.g: If the hysteresis is set to + 2.0°C and a set value is 24.0°C, the cooling
capacity becomes 24.0°C + 2.0°C = 26.0°C and by reaching 24.0 °C is off again. This contact will
remain off until the value rises above 26.0°C.

Output sensor 1 humidify/moisturise:

The procedure is the same as before. When connecting a humidifier, choose the relative humidity =
rH in % at day and at night time and set the desired hysteresis.
Output sensor 1 dehumidify/drying; Output sensor 2 heat; Output sensor 2 cool:
The procedure is repeated for all other outputs as previously.

Output 1 timer:

If you choose the timer function it allows you to enter the start and end time in 24 day cycles. Start
time in hours and minutes, end time in hours, minutes and seconds. There are 25 cycles per output
programmable.
Select the "Ex = timer" Exit 1 timer 1. The first five character 00:00 represents the on-time in hours
and minutes from 00:00 to 23:59. The next eight character 00:00:00 stand for off-time in hours,
minutes and seconds from 00:00:00 to 23:59:59 in 24hour format.
Press ENTER button, the first two character of the switch on time starts to blink. Now you select the
hours for the on-time. Change the value with UP / DOWN buttons and confirm with ENTER. Now the
next two minutes-character of the on time starts to blink. Repeat the process, and confirm with
ENTER. Now blinks the hours of the off time, repeat the process and set the minutes and seconds of
the off time. Save the first program step with SAVE / EXIT. With the DOWN button to enter the next
programming step, it shows on the display Exit 1 timer 02 for the second programming step. Repeat
everything again until you reach the next programming step Exit 1 timer 03. When you are finished,
press the SAVE / EXIT button to save and return to reach the selection menu "Set Exit 1"
To delete a program step, set the time back to 00:00 00:00:00.
When you have finished programming the "Exit 1" press SAVE / EXIT to return to the main menu.
26
16A Fan controller
Exit 1 timer 01
00:00 00:00:00
hh:mm hh:mm:ss
Exit 1 timer 02
00:00 00:00:00
Exit 1 timer 03
end disabled