Graco PD44 Setup And Operation page 13

Purge setup screen
F . 10 Purge setup screen
IG
In the setup mode, each screen can be switched to this
screen through the purge setup button. The contents
and functions of the purge setup screen are as follows:
1. Purge volume: set the target purge volume.
2. Purge flowrate: set the purge flow rate (high speed
and low speed).
3. Low speed position: set the switch position of purge
flow rate, marked by the percentage of the
remaining capacity of the servo valve.
4. Purge alarm time: set purge alarm time.When the
equipment is in standby, the system will start the
countdown based on this time. When the time is 0,
the system will send out the purge alarm signal to
the external control system.
Advanced setup screen
In the setup mode, each screen can be switched to this
screen through the advanced button. Advanced setup
include three screens.
F . 11 Advanced setup screen - 1
IG
The contents and functions of the screen 1 are as
follows:
1. Flow rate unit setup.
2. Language setup.
HMI Operation
13