Table of Contents
Advertisement
10. Notes on Installation
1) This unit is intented for indoor usage only.
2) Must be used under ambient temperature of 0℃~50℃.
3) When the temperature of the drive case is over 50℃ the heat dissipation is required.
4) Should avoid from direct sunlight, magnetic or radioactive when install drive.
5) When connect I/O cable between host controller and drive, must turn off power of host
controller and drive. Otherwise drive can be damaged.
6) Drive and motor should be grounded. To prevent the potential difference with
surrounding control system device, it should be grounded directly to the ground point
as short as possible.
7) When install two or more drives side-by-side, must be installed at a distance of
at least 20mm at the horizontal direction and at a distance of at least 50mm at the
vertical direction.
More 20mm
More 20mm
More 20mm
www.fastech.co.kr - 18
More 50mm
More 50mm
EN
EN
EN
EN
Advertisement
Table of Contents
