Procedure For Inserting The Follower Plate In The Drum - Samoa LARIUS PNEUMATIC HOIST 30 Operating Instructions Manual

PROCEDURE FOR
B N
INSERTING THE
FOLLOWER PLATE IN
THE DRUM
Follow instructions with care. These operations must be
carried out with the pump at a standstill by competent,
trained personnel: shearing hazard.
SHEARING HAZARD
Carefully follow the directions below to insert the follower plate
in the drum:
• Open, loosening the corresponding air bleed rod (N1)
N1
Fig. 1N
The rod should not be completely unscrewed. If so, re-
tighten at least 2 or 3 turns.
• Raise the hoist and position the drum.
Fig. 2N
ED. 01 - 01/2020
NOTE
NOTE
PNEUMATIC HOIST 30
• During this operation, keep drum closing clamp (N2) loose
so that they can auto-centre on the follower plate.
Fig. 3N
• Regulate cylinder pressure to at least 1 bar on the corre-
sponding regulator (N3).
N3
Fig. 4N
• Grease the follower plate gasket.
Fig. 5N
N2
www.larius.com
15