WAGNER WALL EXTRA I-SPRAY 1300 Operating Instructions Manual page 14

GB
10. Move the air cap (Fig. 6, 1) to the vertical position for easier removal and lift it off.
11. Unscrew the union nut (fig. 6, 3). Clean the air cap (1) and nozzle (2) with a brush and
solvent or water.
Attention! Never remove the red nozzle seal from the nozzle. If the nozzle
seal is either missing or damaged liquids can enter the device and increase
the risk of an electric shock.
Assembly
The I-Spray nozzle, air cap and needle are optimally adjusted to suit each
i
other. Do not combine components with different spray attachments, as the
components could be damaged.
CAUTION! The units may only be used with a functional valve. If paints
rises in the ventilating hose (Fig. 1 A, item 13) do not operate the unit
further! Dismantle and clean the ventilating hose, valve and diaphragm
and replace the diaphragm if necessary.
1. Place the diaphragm (fig. 1 A, 15) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2. Place on the valve cover (fig. 1 A, 14) and screw it closed.
3. Place the ventilating hose (fig. 1 A, 13) on the valve cover and on the nipple at the gun
body.
Attention! Never operate the device if the nozzle seal is either damaged or
missing. If the nozzle seal is either missing or damaged liquids can enter
the device and increase the risk of an electric shock.
4. Check the nozzle seal (fig. 7, 16) in the nozzle.
5. Screw the union nut (Fig. 8, 3) onto the gun and tighten it.
Tighten the union nut (Fig. 8, 3) fully so that no paint is able to penetrate the
device.
6. Engage the air cap (Fig. 9, 1) with the union nut. Check that the air cap engages fully
on both sides. (Fig. 10, 1)
7. Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8. Insert the suction tube with container seal in the gun body.
10
Wall Extra I-Spray 1300