Barbecook BANABA Installation Instructions Manual page 18

solVInG problems
Problem
Impossible to light burner (with igniter
or match)
Not enough heat
Yellow flames
Impossible to light burner with igniter
Flames jumping out of the burner box
Excessive heat and flare-ups
Flames behind control panel
Regulator humming
Incomplete flame
Warming rack does not fit
TroUblesHooTInG GUIDe For eleCTrIC IGnITIon
Problem
No sparks when pressing the ignition;
no sound
No sparks when pressing the ignition;
sound is present
Sparks are present but not with all elec-
trodes and/or not powerful enough
TURBO HEATING SYSTEM
An additional feature is the new Turbo Heating System: your
barbecook is immediately ready to grill and the heat is distri-
buted optimally.
DE
HANDBUCH FÜR MONTAGE,
BETRIEB UND WARTUNG
SICHERHEITSINFORMATIONEN
DIESES GERÄT IST AUSSCHLIESSLICH
FÜR DEN BETRIEB IM FREIEN BE-
STIMMT. BEI GASGERUCH:
26 www.barbecook.com
Probable cause
• B locked venturi tubes
• G as cylinder valve is not open
• V enturi tubes not positioned over exhaust valves
• B locked burner openings
• C ylinder is empty or almost empty
• R egulator not fitted correctly on cylinder
• V enturi tubes are partly blocked
• S alt on burner
• T he product is connected to Buthane.
• I gnition wire not fitted properly
• D efective ignition electrode
• F aulty ground
• D efective igniter
• W indy weather
• C ylinder almost empty
• T oo fatty food
• B locked fat drain hole
• C ooking system not positioned correclty
• B locked venturi tubes
• T emporary situation caused by high outside temperature or
full cylinder
• P lugged, leaky or rusted burner
• L egs are angled too narrowly, or too widely
Probable cause
• B attery not installed correctly
• E mpty battery
• I gnition button not installed correctly
• D efective spark generator
• F aulty ground
• F aulty ground
• S park flashover away from burner(s)
• L ow battery
• E lectrodes are wet
• E lectrodes cracked or brokenn "sparks are present"
1. DREHEN SIE DIE GASZUFUHR AB.
2. LÖSCHEN SIE EVENTUELLE
FLAMMEN.
3. ÖFFNEN SIE DEN DECKEL.
4. RUFEN SIE UNVERZÜGLICH IH-
REN GASVERSORGER ODER DIE
FEURWEHR AN, WENN DER GAS-
GERUCH NICHT VERSCHWINDEN
SOLLTE.
Solution
• C lean venturi tubes
• O pen gas cylinder valve
• R einstall venturi tubes
• C lean openings or fit new burner
• N ew cylinder
• T ighten up connector of regulator
• D isconnect hose
• C lean venturi tubes
• C lean burner
• C onnect the product to Propane with the right connector.
• C heck all connections
• C heck installation of electrodes, burner and igniter
• R eplace igniter
• M ove barbecue with rear side pointing towards the wind
• N ew cylinder or fill up
• T rim excess fat or reduce heat
• C lean bottom of burner box and burner
• P osition cooking system correctly
• S hut off gas immediately, allow barbecue to cool down and
clean venturi tubes
• T his is not a defect or a hazard
• C lean / replace burner
• T he warming rack feet are adjustable. Bend them to fit into
the warming rack holes.
Solution
• I nstall battery (ensure that Ò+Ó and Ò-Ó are oriented cor-
rectly, with Ò+Ó at the top and Ò-Ó at the bottom)
• R eplace with new AA battery
• S crew off button and reinstall
• R eplace spark generator
• R emove and reconnect all connections with spark generator
and electrodes
• R emove and reconnect all connections to the spark genera-
tor and the electrodes
• I f sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• R eplace with new AA battery
• U se paper tissues to remove the dirt
• R eplace cracked or defective electrodes
Advantage: barbecook uses 20% less gas than any other gas
barbecue.
• DER BENUTZER IST FÜR DIE ORD-
NUNGSGEMÄSSE MONTAGE UND
SACHGEMÄSSE VERWENDUNG DIE-
SES GRILLS VERANTWORTLICH.
• DIE NICHTEINHALTUNG DER ANWEI-
SUNGEN DIESES HANDBUCHS KANN
ZU FEUER- UND EXPLOSIONSGE-
FAHR FÜHREN.
• DIE NICHTEINHALTUNG DER ANWEI-
SUNGEN DIESES HANDBUCHS KANN
ZU SCHWEREN VERLETZUNGEN UND
SACHSCHÄDEN FÜHREN.