FENDT CARAVAN 2021 Operation Manual page 94

9. Gas
1
TRUMA – Combi C4 / C6 (E)
(model-specific/accessory)
The flow control and thus the efficiency of the two water circuits (living
room/bedroom) can be regulated by means of the shutoff valves.
One shutoff valve is located in the seating bench in the front (right-
hand side in the direction of traffic) and one in the bedroom.
The photo j on the left shows a shutoff valve that is closed.
2
The photo k next to it shows the water circuit when it has been
opened approx. 50%.
TRUMA - Combi C4 / C6 (E)
The TRUMA Combi fluid heater is a hot-air heating system with an
integrated hot-water boiler that holds 10 litres.
When the heating and/or hot-water system is in operation, the room
will be heated and, at the same time, so will the water. If only hot
water is required, it is possible to operate only the hot-water system.
If you have selected the 'E' fitting package (model/series-specific;
optional extra) the device also has additional heating rods for electric
operation.
You are not permitted to operate the heating system
while driving.
Exception: when using a licensed gas flow monitor
(e.g. Truma-SecuMotion or Duo-Control CS).
Before first use
• Several air outlet nozzles have been built into the caravan.
Pipes lead the hot air to the air outlet nozzles. Turn the nozzles
so that the hot air is expelled where you want it.
• Check whether the flue is unobstructed. Any covers must
always be removed.
• Open the bottle valve and the quick-close valve in the gas line.
• If necessary, fill the boiler with water.
• Use the control panel to switch the device on.
To start the device, the heating system must either
be connected to a 230V power supply or 12V via the
caravan's battery, should you be using a stand-alone
power supply.
Please refer to the manufacturer's TRUMA ® separate
operating manual for detailed handling information.
90